crystaldiskinfo 話個hdd 有100度？

諗住買個二手hdd ， 見到呢個hdd 幾平。但見到個溫度係100，想問係咪正常？定係個數字係俾人改左

30度喎.... 你睇咩100度...呀?

下面c2個row寫100

加個錫紙兜可以煎蛋

Three values are associated with each S.M.A.R.T. attribute:

"Normalized value", commonly referred to as just "value". This is a most universal measurement, on the scale from 0 (bad) to some maximum (good) value. Maximum values are typically 100, 200 or 253. Rule of thumb is: high values are good, low values are bad.
"Threshold" - the minimum normalized value limit for the attribute. If the normalized value falls below the threshold, the disk is considered defective and should be replaced under warranty. This situation is called "T.E.C." (Threshold Exceeded Condition).
"Raw value" - the value of the attribute as it is tracked by the device, before any normalization takes place. Some raw numbers provide valuable insight when properly interpreted. These cases will be discussed later on. Raw values are typically listed in hexadecimal numbers.

https://www.z-a-recovery.com/manual/smart.aspx

係 個果係smart 值黎

真係wo. 多謝師兄。我睇左其他東芝既都係100 點解咁奇怪嘅。 我自己部機兩塊wd 出個數都相當接近最頂出個溫度

我好似明左小小。係咪要睇個raw value

下面堆數值只係參考個hdd健康度
實際溫度30人地已經比埋你，你咁都唔信不如自己買裝備去測啦

係，0x1E = 1×16^1 + 14×16^0 = 30

Sor