iPhone 11 PRO / PRO MAX 討論區 (6)

用pro max隻眼好易乾同唔舒服，有冇方法較到？
唔
唔通要換埋11

唔好起暗既地方用太耐

Pro好似真係收得好左

開燈用都係一樣情況，已經盡量較暖色。

已由8仔轉pro max
一開始唔係好慣咁大部
幾日已經習慣

有冇人個lock制有delay?

咁睇黎都出pro
因為現場玩過實物大mon係幾正 但帶埋case會好重

少玩啲, 同屋企人或friends 傾多啲解

no

有冇人iphone 11 max 雙卡信號出問題？
有時send wtsapp都要等好耐 玩即時遊戲會斷線
以前由iphone 6換到x 都未遇過

正常嘅，因為㩒兩下開apple pay

想問點整個快捷icon鎖機

去apple pay 熄左㩒2下比錢

充電用原裝嗰個快差定用ipad個個好 之後部7一直都用ipad個個

但係用電話睇幾條片都已經唔舒服...
係咪我隻眼太廢

The PWM brightness regulation is another typical characteristic of an OLED panel, and this is the case for the iPhone X as well.(ihpone 11 pro max as well) We can measure a comparatively low frequency of 240 Hz as soon as the luminance is at 50% or below. Sensitive users should get the iPhone 8 / 8 Plus with an LC display, where we did not determine PWM. In addition to the 240 Hz PWM, we can also measure a slight flickering at 60 Hz (see screenshots below) at higher brightness levels (even at the maximum).

電圖呢？

The display backlight flickers at 240 Hz (Likely utilizing PWM) Flickering detected at a brightness setting of 100 % and below. There should be no flickering or PWM above this brightness setting.

The frequency of 240 Hz is relatively low, so sensitive users will likely notice flickering and experience eyestrain at the stated brightness setting and below.

In comparison: 51 % of all tested devices do not use PWM to dim the display. If PWM was detected, an average of 9418 (minimum: 43 - maximum: 142900) Hz was measured.

正常， oled特性， 同埋個mon 會偏黃

大家點樣tran返啲sticker去新機㗎

pro max 叉電個MON好暖，好不安

即係點......

今日買咗11 Pro Max 256GB space gray，依家唔捨得瞓